Re: introduction

hi how do i view message board thanks todd
----- Original Message -----
From: <omniverse@...>
To: <omc-boats@...>
Sent: Thursday, October 25, 2001 8:52 PM
Subject: Re: introduction

> On Sat, 13 Oct 2001 16:36:43 -0400
> "todd" <bocky@...> wrote:
> > hi my name is Todd DeBockler i live in P.A i am the
> > owner of a evenrude 15.5 foot inboard outboard boat looks
> > just like the boat in national geographic 1965 except the
> > one in the mag is a outboard when i got the boat there
> > was no trailer i finally picked up a trailer i dont know
> > much about boats put i am mechanical the motor is
> > out of the boat i was told the motor was thought to be
> > sized but when it was taken out all the matter was the
> > starter nose was cracked and the starter gear was jamed
> > now with the boat on trailer i will put motor back in
> > any help sugestions will be appricated thanks todd
> > bocky@...
>
> Hi Todd,
>
> Have you got the model or serial numbers, those help a lot
> to discern what's what.
> If you haven't seen it already, I put a color wiring
> schematic online which could be downloaded and followed
> easier (IMHO) than the B&W original it was traced over. It
> probably follows a few boats/years in general, but is
> basicly for the '66 Evinrude 90HP I/O OMC.
>
>
http://webpages.charter.net/omniverse/'65-'68%20OMC%20Wiring%20Schematic.jpg
>
> [sorry but %20's and capital letters must be used in above
> URL]
>
> Although I haven't pulled my motor out or even dismantled it
> (yet) beyond the carburator I have some leakage at the back
> where the block meets the transom housing. So if anything,
> you'll want to get a good seal on that.
>
> Farewell,
> Bob Hughes
>
Received on Thursday, 25 October 2001