In a message dated 4/29/06 7:11:01 PM Central Daylight Time,
scottveazie@... writes:
<< I think the ballast resistor I have
was too limiting, which caused it to die at certain low rpms, but run out
fine. >>
Measure the DC voltage at the coil with the key "on". It should be around
6-8 volts.
I've found that the points often get oxidised and a good indicator of that is
that when you give the motor full throttle, you lose power from the weak
spark.
It may affect the idle as well. You've cleaned the cap, rotor and points?
Coil
is good? Plug wires are good ?
If you are getting a healthy spark, it might be another issue.
Lee Hazen
-----
To get off this list send mail to omc-boats-unsubscribe@...
Received on Sunday, 30 April 2006
This archive was generated by hypermail 2.2.0 : Tuesday, 29 July 2014 EDT