In a message dated 4/30/06 9:46:51 AM Central Daylight Time, LeeHazen@...
writes:
<< << I think the ballast resistor I have
was too limiting, which caused it to die at certain low rpms, but run out
fine. >>
Measure the DC voltage at the coil with the key "on". It should be around
6-8 volts. >>
Another area to check, clean the fuse and fuse clips in the fuse block in
the dash. "Ign" fuse may be contaminated limiting the current that can flow
through the coil.
A thorough cleaning of the entire fuse holder assembly is a good idea for a
boat that's 35 years old.
Lee Hazen
-----
To get off this list send mail to omc-boats-unsubscribe@...
Received on Sunday, 30 April 2006
This archive was generated by hypermail 2.2.0 : Tuesday, 29 July 2014 EDT